Removable window grilles8/25/2023 Before finally tightening the top and bottom retaining units the end caps should be moved out to the end of the opening, this will provide a neat and even finish to the system.Mc.2 is known as the leading brand for smart blinds and curtains in Singapore. For wider or horizontal applications, the fixing plates can be secured within the retaining unit by using maskin tape or a small amount of silicone sealer (this will eliminate fixing plate movement). It is usually necessary to create a small recess directly below the lock position and to allow the bottom fitment to seat correctly. It is very important that countersunk screws are used these will allow greater clearance in the top retaining unit. We recommend that the minimum fitting is 10 x 2" (50mm) countersunk wood screws. The retaining unit can then be removed and create space to drill the appropriate hole. The top and bottom retaining units should be placed up by the window and the fixing positions marked with a pencil. With a SeceuroBar, the system is manufactured to fit as close as possible to the window frame this will avoid any unnecessary gaps for dust, dirt etc. To view further information on the SeceuroBar Removable Window Bars, please click here > ![]() When mounting the bars horizontally the lock must always be fixed on the left hand side looking from inside out. The system can be supplied (at additional cost) with pre powdercoated 50mm x 50mm aluminium packers to face fix it to any wall. When mounting the bars horizontally the lock must always be on the left looking from the inside out. The maximum width for a window bar fitted horizontally is 2000mm. When measuring for window bars which are fitted horizontally you must provide the width and height as shown in the diagram. ![]() The reveal should be levelled up with packing strips and re-measured. If the reveal slopes inwards or outwards, or the top retaining unit is not fitted directly above the bottom retaining unit, the sockets will not lock in the slider mechanism. Packing strips can be used to make the reveal level. You must check that the reveal is straight and level, any deflection of the bottom retaining unit will cause the mechanism to stick. If the reveal construction is solid steel or a cavity then it would be better to face fix the system around the opening. The SeceuroShield bars are powdercoated in Semi-gloss White RAL 9016 as standard with a choice of powdercoated colour options at extra cost. To view the specification sheet on the SeceuroBar window bars click here PDF > The key must always be pressed in before any key rotation is possible. ![]() The removable window bars are operated by a single radial lock point. The width is pretty much the same, taking the smallest width measured and taking a small tolerance off for fitting and then you have the ordering width.Įach bar is prefinished in RAL 9016 white in a tough and special paint finish with a satin finish. The main fixings are into the top and bottom steel retaining sections and for measuring simply take the smallest height and deduct a small tolerance of 5-10mm which then gives you the ordering height. You can remove one, several or all the bars as required and what is left is secured by the key lock again.Įach bar rotates in its individual position so any attempts to cut the bars uisng a hack saw or similar will not be successful. ![]() Strong extruded aluminium retaining units secure each bar, yet the unique locking system means that they can be released in seconds for access to clean or simply have the window without the bars. The Seceurobar removable window bar system uses tough powdercoated round steel bars which are locked in place on the inside of windows, in either vertical or horizontal format.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |